Air source Heat Pumps

The power flushing pump is simply connected into the heating system, either across standard circulator pump couplings, across the tails of one radiator, or wherever most practicable. The powerful flow, combined with instantaneous flow reverser device, will dislodge and mobilise deposits and corrosion which resist traditional system cleaning methods.

Once the corrosion and sludge deposits have been loosened and mobilised, fresh clean water is forced through the heating system, pushing the contaminated water out through a full bore dump valve to waste. During the process, radiators are individually flushed, without removing or disconnecting them from the system, by directing the full output of the pump through each radiator separately.

At the end of the flushing process, the system contains fresh clean water and reinstatement of the system to normal operation takes only a few minutes. System flushing will not remedy design or mechanical faults, which should be rectified, but in many cases it will cure the problems caused by these. Call now for more information & a Quotation. Revitalise your whole heating system- book a power flush today!

Booster Pumps

Problems with low water pressure? Need a set installed for a new building? Old System need replacing? Water unfortunately doesn’t flow uphill and the design considerations required to ensure a steady flow can often be problematic and complex. Though there have been advances in water boosting technology the demand for improved mains water pressure has increased significantly in the past few years due to the lowering of mains water pressure in both rural and urban areas by water companies cutting costs.